Unpacking
Unpacking
Remove screwdriver
Remove Screwdriver
This is for the bed
This is for the bed
Remove screws and svae
Remove screws and put aside
This is for the lower front
This is for the lower front of unit
Unscrew
Unscrew
The Air Diverter
The Air Diverter
Remove loose items
Remove loose materials
The Ultraviolet Light
The Ultraviolet Light
Remove the side covers
Remove the side covers
End pieces
End pieces of unit
Lower part
The lower part of unit
Flat-top and Round-top Screws
Flathead and Roundhead Screws
Assembly
Assembly
Assemble pieces with red dots
Assemble pieces with red dots
Make sure it's snug
Make sure it’s snug
Use round-top screws to secure pieces together
Place roundhead screws in place
Screw in screws
Tighten roundhead screws into unit using provided screwdriver
Put air vent in place
Put Air Vent into place
Secure using round-head screws
Secure using roundhead screws
Secure using round-head screws (different view)
Tighten using roundhead screws (different view)
Round-head screws
Put roundhead screws into place
Secure round-head screws
Secure roundhead screws
Gently place unit on it's back
Gently place unit on it’s back
3" Wide Plexiglass
3″ Wide Plexiglass
Remove protective paper from plexiglass
Remove protective paper from plexiglass
Place plexiglass in place
Put plexiglass on unit
Use flathead screws to secure plexiglass. NOTE: Make sure screws are snug but do not over-tighten or risk cracking plexiglass.
Use flathead screws to secure plexiglass. NOTE: Make sure screws are snug but do not over-tighten or risk cracking plexiglass.
Join the top and bottom of unit
Join the top and bottom of unit with hinges
Remove protective paper from larger, white plexiglass
Remove protective paper from larger, white plexiglass
Place the plexiglass on front of unit
Place the plexiglass on front of unit
Use roundhead screws to secure plexiglass to unit.  NOTE: To avoid cracking plexiglass, do not over-tighten screws.
Use roundhead screws to secure plexiglass to unit. NOTE: To avoid cracking plexiglass, do not over-tighten screws.
Add Velcro to upper left area of the unit (left side if looking at incubator from the front).
Add grey Velcro strip to upper left area of the unit (left side if looking at incubator from the front).
Secure thermostat to unit using Velcro
Secure thermostat to unit using Velcro added in prior step
Install thermometer
Install thermometer
Secure thermometer into place using roundhead screws
Secure thermometer into place using roundhead screws
Gently turn unit upright
Gently turn unit upright
Install transparent cover/lid using flathead screws
Install transparent cover/lid using flathead screws
Gently open incubator for interior assembly
Gently open incubator for interior assembly
Install lightbulbs
Install lightbulbs
Install Diverter
Install Diverter
Connect electricity
Connect electricity
Adjust/test thermostat
Adjust/test thermostat
Incubator installation is complete